I might as well post it here .
The way the custom phase distortion interpolates between the phasor breakpoints is completely wrong
Proof is in the pudding , a simple sine to saw (first shape ) requires the movement of just one beakpoint but even that can't be achieved in the custom shape.
I tbehaves correctly when you manualy drag a point , but once it interpolates it does not behave as it should
See picture , the yellow BASE line reads the cosine in a straight line , no phase disortion going , the blue line is the TARGET , expected behaviour of the dcw is indicated by the red line , it should move across the X-axis
Instead it moves the (invisible) breakpoint on the blue line down across the Y-axis indicated by the white arrow , this is not how it's supposed to be and does not sound remotely similar to the othewise excellent emulation
If it would be correct , the custom shape would be able to replicate the build in algoritm saw into sine , which it can't
I made a giff
This is how phase distortion on a cosine actually looks like , result sine turns into saw
The green line represents the phase accumulator (range 0-1)
The green breakpoint is where the phasor is distorted ,everything at the left of the breakpoint represents 1pi rad ( 2 quarters of a cosine ) , at the right of the breakpoint also 1 pi rad( again 2 quarters of a cosine) , together 2pi rad =cos.
Result is skewed cosine , skewing it hard enough gives you a saw wave
This is exactly how the cz does it and so does the arturia with the build in algoritms , except the custom wave
The breakpoint should remain at all times at level 0.5 , on the custom cz shape it does not
