Author Topic: Sequencer Question (Read 5354 times)

MarkM · « **on:** February 01, 2005, 07:28:39 pm »

Can someone tell me what to do with the trigger inputs and "On" buttons located on the far right hand side of the sequencer? They are under "Columns" and right next to the "smooth" knobs. I have toyed with them and can't seem to figure out what to do with them. The manual mentions them but doesn't tell you what they accomplish.
Thanks,

MarkM · « **Reply #1 on:** February 04, 2005, 02:26:07 pm »

I take it since nobody answered then nobody knows what they are for?

ed · « **Reply #2 on:** February 06, 2005, 01:04:15 am »

I'd like to know what they're for too Mark

Anyone ?

behrenbeck · « **Reply #3 on:** March 08, 2005, 10:09:32 pm »

Hi Mark!

sorry that i cannot help but i would like to lnow this, too.

Werner Behrenbeck

MarkM · « **Reply #4 on:** March 09, 2005, 01:24:26 am »

Hopefully somebody will see this post and have an answer. I wonder if they are for some future use?

FabP · « **Reply #5 on:** March 09, 2005, 09:09:17 am »

The "ON" buttons are used to retrigger the corresponding line of the sequencer, as the "ON" buttons at the bottom of each column are used to make the sequence jump to the corresponding step.
The input beside the buttons are useful to plug any trigger signal (keyboard, etc...).

You must have a sequence with more than one active line if you want to use the right trigger buttons. (For example "chain : L321"...)

MarkM · « **Reply #6 on:** March 10, 2005, 01:36:35 am »

Thanks. That makes sense.