Problems with my Origin, (Leds, push buttons...) since this morning...

[Jeruro]

I started  my Origin this morning and I found that the buttons and LED's do not respond correctly. I attached 4 photos in the following link: http://www.megaupload.com/?d=3KB48EQM

As you can see in the photos:
 1-I have only one effect in the slot nš1 but two of the leds in the effecs section are ON. If i push these butons the not respond normally ( the leds change their state simultaneusly, etc..)

2- The Demo Led remains always ON.

3 - If i push Mode button on the Joystick seciton, the Demo led goes then Off.

4- In the sequence section you can see the Trig and Slide leds at ON state at same time!!

And a lot of others things. I think my unit is defective 4 months later. LOL   

My current fimware version is 1.3.23. Sorry for my bad english i'm from Spain.

I send a message to the tech support regarding this problem, now i'm really afraid.

[Jeruro]

Now my unit has been hanged a couple of times pressing some ON/OFF buttons...

[moogy blues]

I've had problems typing in preset numbers using the keypad where the number will not input on the display screen. The screen tends to flicker a bit during typing