Arturia Forums
Harware Legacy versions => Origin => Origin Technical Issues => Topic started by: Jeruro on February 12, 2011, 10:53:41 am
-
I started my Origin this morning and I found that the buttons and LED's do not respond correctly. I attached 4 photos in the following link: http://www.megaupload.com/?d=3KB48EQM (http://www.megaupload.com/?d=3KB48EQM)
As you can see in the photos:
1-I have only one effect in the slot nš1 but two of the leds in the effecs section are ON. If i push these butons the not respond normally ( the leds change their state simultaneusly, etc..)
2- The Demo Led remains always ON.
3 - If i push Mode button on the Joystick seciton, the Demo led goes then Off.
4- In the sequence section you can see the Trig and Slide leds at ON state at same time!!
And a lot of others things. I think my unit is defective 4 months later. LOL >:(
My current fimware version is 1.3.23. Sorry for my bad english i'm from Spain.
I send a message to the tech support regarding this problem, now i'm really afraid.
-
Now my unit has been hanged a couple of times pressing some ON/OFF buttons...
-
I've had problems typing in preset numbers using the keypad where the number will not input on the display screen. The screen tends to flicker a bit during typing