Arpeggiator not working

[MarkFromGermany]

I'm hitting a couple of problems with the arpeggiator!

(factory init preset, paraphonic mode, sync source set to INT, arp sequence icon is set to Up, OCT/MOD is set to 1)

1. In arp mode the arpeggiator plays the chord tones only once!
It doesn't matter if I hold the chord manually or if I'm using the Hold function
And adding to that, the order of the notes played does not match the selected upwards order
(ladder icon)
For example I'm holding C E G, it should play C E G in that order, right?
But actually what I get is C G E!

2.When I switch into the arp mode, and I'm already holding down a chord, 
the mF goes silent almost immediately (the chord played sounding out, then dead silence).
Again if the chord is held down manually or using the Hold function, the outcome is the same.

Please, can you help me with this?

Cheers!


edit #1: the mF runs on the newest FW!

edit #2: synced the mF with my BSP  and haven't had nay issue after a short test. So it must be that hooking up the mF to a computer/DAW (ableton 9.7/wind 7 in my case) has some correlation to the problem. Remember even with sync source set to INT
the arp didn't run properly.

[Trevor42]

Arp also doesn’t hold chord sequence with an external midi keyboard.

[Edouard_Arturia]

Hey Trevor.

It sounds like a MIDI loop: Microfreak sends notes to the DAW > DAW sends the notes back to the MicroFreak
The result is usually notes being cut, and ARPs as well.

Kind regards

Edouard

[MarkFromGermany]

Hey Trevor.

It sounds like a MIDI loop: Microfreak sends notes to the DAW > DAW sends the notes back to the MicroFreak
The result is usually notes being cut, and ARPs as well.

Kind regards

Edouard

Thanks a lot!
 woohoo it works now!!!

I haven't thought about a potential mid loop, (set input chan to none)