Hello,
I just bought a MINILAB mk2 on the second hand market a couple of days ago because I needed a small midi controller for using my Analog LAB3 software which I purchased in this January. All the knobs are working as seen in the midi console inside the midi control centre, but when I am using Analog lab 3 the knobs 10-11 and 13 are not working. I know there are a lot of issues about 'jumping knobs' but these knobs are not doing anything. My firmware is 1.0.9.83 and for Analog LAB3 3.0.2.1289. Is this a common issue? Should I return this model and buy a new one?
(I am using macOS 10.13.3)
