I set the key step to Cv Pitch = HZ/V and Gate to S-TRIG, but when I go up and down octaves, the pitch drifts dramatically. It also doesn't seem to accurately raise/lower octaves when connected in this manner.
If I control the MS20 via midi, I don't seem to have any pitch or octave assignment issues, but the Mod and Pitch wheels on the Keystep don't work then. I can keep the MIDI connection and additionally patch the CV Mod out to the MS20's Mod in and get the Mod wheel going, but still no go with the Keystep's pitch wheel.
Is it possible to address the CV pitch problems? If it offers any clues, an existing sequence I've programmed sounds an octave higher via CV connection (using Pitch Out+Gate Out+Mod Out) vs MIDI (MIDI Out+CV Mod Out).
