V3 Manual Confusing - Could someone help clarify?

[craftycurate]

Hi

I'm following the example on p55 of the manual in the section on the Sample & Hold module of ARP2600v3.

Bullets 1 and 2 are fine, but what on earth does "Connect output C of the interrupter to one of the filter modulation inputs" mean? I cannot find an "output C" of an interruptor in this module.

Can someone help clarify what this is referring to? Is it part of the S&H module?

Cheers
Richard

[LBH]

You are looking at this section:
4.1.9 The “electronic switch” module (Electronic switch)

It's the "Electronic Switch Module" not the "Sample and Hold". I too think it's not clear.

If you look at the picture "The electronic switch" in the section, then you can see the letters "A" and "B". It's possible to see what connections that are.
You are right it's hard to see what "C" is. The letter is not there. But if you draw a straight line down from "A" thru "B", then the next connection you hit is connection "C". A orange line go straight down to it. Would be nice if the letter "C" was there.

Hope this help to clarify.

[craftycurate]

That's what I was looking for

Thanks for your help
Richard

[jeffbart]

It's been discussed here
http://forum.arturia.com/index.php?topic=87822.0

cheers Jeff