Midi Control Center Not Seeing BSP after Firmware Update

[darknoiseattrator]

I successfully updated my BDP to firmware 1.1.6, but afterwards, the Midid Control Center will not sync, displaying the message "Error. Device not found." I'm on an iMac running OS 10.9.5. Previously it was fine and I did not have this issue with the first BS. I have made sure that the BSP is not appearing as a device in Apple's Midi Setup.

Suggestions?

[Terrym]

Hi try going to audio midi setup app and deleting the beat step pro driver then plug  the Bsp usb back into your computer see if that cures your problem


regards


terrym

[darknoiseattrator]

See the attached screenshot. The Audio Midi Setup does not have the BSP shown, but the Midid Control Center will still not see my BSP. As I said, I actually did do a firmware update, but immediately afterwards I could not sync.

[floThePro]

hmmm....
what does the BSP display say?
"UPD"?

I had to repeat and repeat and wait "longer".......then it works! ,-)

[darknoiseattrator]

Well, the update worked and installed. This is after the update and trying to sync with the Midi Control Center.

[Terrym]

Open up the audio midi setup page bigger it is there but hidden . then make sure the bsp is not connected and delete the driver and then reconnect .


Terrym