Hi everyone,
As some other people before, I also have the problem with my new KeyLab 88, that my sustain pedals polarity is reversed. If it is not pressed, the value is 127 and if I press it down, it is 0. I tried reversing it in the MIDI Controller with the result, that it just simply stayed on 127 no matter if I press it down or not.
Has somebody a solution for that? From previous forum posts it seems like nobody found a solution yet.
I tried fixing the problem by installing a firmware update (my KeyLab is running on 1.0.0.8 ), but as I tried installing 1.0.0.10, I got the following error message: "There was an error during the burn process: Please reset the product and retry again"
So I tried resetting the keyboard, holding both octave buttons as I plug the USB cable in, but it didn't tell me if it worked. And afterwards I still couldn't install the new firmware.
Any suggestions for how to fix that problem?
I'm using a MacBook Pro 13 Retina with Mac OSX Yosemite 10.10
I hope you have a solution?! The Tech support doesn't seem to receive my contact message.