Sequencing via Gate in

[slinky]

I have a Boss Dr-110 drum machine sending a trigger out to the gate in of my Microbrute.  Is there a way to make trigger the notes of the sequencer.  As it is it just seems to trigger the last note played on the keyboard.  I used the software to change the sequencer to gate mode, but this did not seem to work.
Thanks!

[Bruno@arturia]

you need to use Connection software. Set "Step On" option to Gate

[jwein]

you need to use Connection software. Set "Step On" option to Gate

With that option on, what happens now  if the LFO-Out to the Gate-In Connector on the Backside of the Microbrute? Would it be possible to control tempo of the sequence with LFO-Rate?

[ben arturia]

Hi jwein,
It seems to work great.
Rate can go 99% but if you put it at max the sequencer stops.

[SampleHold]

I set this up yesterday with my DR-55, and while it does sync, it does not sustain the sequenced note very long. Since the Gate In is in use, I cannot patch over from the Gate Out to correct. Please advise. I need the notes to be held for a very slow, droning sequence.

Can we get a firmware patch to enable longer release times globally (max release slider position = hold) like the hold switch on the back of the Mini, or is this a hardware limitation?