December 08, 2023, 03:29:56 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Update 5 bricks Microfreak  (Read 575 times)

stuzog

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Update 5 bricks Microfreak
« on: May 26, 2023, 09:37:40 pm »
Update 5 was interrupted before completion on Mac M2 Air latest Ventura. Now stuck with only Utility light on and MIDI Control Center showing Device not connected in blank right-hand pane. Is there any way of getting out of this state? I note that nobody on this Forum has ever received a solution from Arturia on this. Is this MicroFreak now bricked forever?  ???

Guest

  • Guest
Re: Update 5 bricks Microfreak
« Reply #1 on: May 30, 2023, 06:59:05 pm »
I am a Windows user but I resolved it by clicking in unknow firmware revision and start updating again. You can choose an old firmware file or try the new one again.

demotricus

  • Guest
Re: Update 5 bricks Microfreak
« Reply #2 on: May 30, 2023, 11:38:27 pm »
Same kind of issue here. The update seemed ok until I cycled the power. When it powered up, all the patches had been wiped. (just showing 'init') & I was unable to transfer them within midi centre. I've managed to roll back to the previous firmware ( 4_0_3_1625 ). Hope they fix this, I was looking forward to the new sample and granular engines.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines