Hello people, I will tell my problems.
First I connect Artruria minilab mk2 to the Mac Pro with the original provided usb cable.
It connected well and I open the midi control center.
I get the firmware update.
When I set my pad or knobs for midi CC, (For example, I set pad 1,2,3 for Midi CC #1, #2, #3 each with the color. And the other pads are original default settings.)
it saved well.
I can see the color change after I store to the other banks (2,3,4,...)
Also the control center shows that each pad send midi CC appropriately when I see the arrows.
HOWEVER, when I save it all and check the AUDIO/MIDI settings on Mac Pro, I was very embarassed.
When I check it through test mode on that options, the other previous default buttons, knobs, keypads, work well,
However the only things that I set for MIDI CC (the pad 1,2,3)didn't send the messages!
I checked the channel, but it is same setting with the default setting's channel.
I realize that if the pads and knobs didn't send midi CC when I store to template 2,3,4... (1 is default settings.)
What should I do?
