(SOLVED) Drum CV Gates not working

[Kubase]

This is with various eurorack modules.  No problems from the Seq 1/2 gates but nothing coming out of any of the drum CV gates.  I've tried the positive/negative settings in MCC.

Help!

 

[I grec]

Hi Kubase,
Are you sure about the pads that are used are the ones linked to the Gates?

I Grec.

[Kubase]

Hi, yes I'm sure. The gates also don't work with sequencer steps, not just hitting the pads.

[I grec]

Have you check the output voltage of drum gates?
You may have to check your Drum Map

Y.

[Kubase]

How do I check the voltage. I don't think it's related to a drum map as I am trying to trigger eurorack modules.

[I grec]

How do I check the voltage

With a multimeter. Maybe your unit is faulty.

I don't think it's related to a drum map as I am trying to trigger eurorack modules.

My mistake, you are right.

Y.

[Kubase]

Hi, I don't have a multimeter.

[I grec]

Ok,
Let's try some trick:

• Put a jack cable (Mono) between "DRUM GATES" output 1 and "CLOCK IN".
• Put your BSP in SYNC -> CLK
• Put your BSP in DRUM sequencer mode
• Then press Play button
• Push the Pad labelled "C Forward" a lot of times

The sequencer should increment itself. Tell me if it is ok.

Y.

[Kubase]

Hi, that worked!  What's even better is that after going back into midi synch mode, it still worked!  Everything else was set up identically.

Thanks, case close. 

[brennyb]

very helpful indeed , same issue solved