Sequencer - problems with setting accents value

[Mallorn]

Hello!
When I am in Seq mode and try to set values in Accent row, I have following problems:
 I cannot set values (the knob does not respond, always showing + or - 0%). After pushing Play and Rec together the values are shown, but instead of Accents row, the MOD row starts to light (without even touching it) in random places.
How should I fix it?

All the best
pat

[Alexandrejoe]

hello!
Unfortunatly sequencer's Accent is only ON/OFF so you can't set any value for this parameter.

[Mallorn]

Absolutely right. Thank You.
I forgot, that setting values is possible only in the MOD row.
But - anyway - this function does not work properly. Buttons respond or not, sometimes I have to push them twice, almost every time when I use Sequencer I have to reset it. Annoying.
Thanks again.
All the best
pat

[DrJustice]

...
But - anyway - this function does not work properly. Buttons respond or not, sometimes I have to push them twice, almost every time when I use Sequencer I have to reset it. Annoying.
...

It should not behave like that. The buttons respond every time and there are no sequencer bugs that require frequent resets. If yours doesn't work well, make sure you have the latest firmware installed (1.1.0.73), and if you do, perhaps try a reinstall.