hey all,
i really love the beatstep pro and i thought about additional features and how to involve them
to the existing firmware:
COPY STEP:
reason* sometimes its a mess to rotate the encoders to hell and heaven just to set values of all steps
to the same state:
PRESS and HOLD the source STEP to copy, then PRESS and HOLD SHIFT followe by pressing RECORD to COPY the STEP "in the buffer"
PRESS and HOLD the destination STEP, then PRESS and HOLD SHIFT followed by pressing PLAY. the pressed STEP now has the informations of
the source step .. will evolve the workflow dramaticly. try it out arturia how fast you create more interesting patterns without wiggling the pots to death !
PATTERN ITERATION:
PRESS and HOLD SHIFT followed by PRESSING and HOLDING the desired SEQUENCE BUTTON . hold it down! . now press << or >> to move all steps
of a sequence one step back or forth
SINGLE DRUM ITERATION:
PRESS and HOLD SHIFT followed by PRESSING and HOLDING DRUM (left hand) + desired DRUMPAD BUTTON (right hand) ** ..
now press << or >> to move the TRIGGERSTEPS of a single DRUMPAD
** alternative LED BLINKIN could visualize a LATCH STATE for this COMMAND ??
PATTERN CHANGE BEHAVIUR:
SHIFT + PRST LNK + any SEQUENCE activate pattern change ONLY AFTER the last step of the choosen SEQUENCE is reached
do the combo again on the same SEQUENCE again deactivate this mode
PATTERN CHAIN:
*PRST LNK active !
select any sequence, PRESS and HOLD down SHIFT+RECORD+PLAY, press the steps to get chained, blinking led as activation respone ?!
could be the beginning of a songmode
there is just the question left if there is a four bar long sequence and a three bar long sequence and
where to change the pattern then .. set priority anyhow?
would also be possible to use the encoders for changing the repeat (03x, 05x, 1x, 1,5x, 2x .. etc) of the pressed CHAIN STEP
would be great to get some feedback by the commi and the makers
great tool .. hope it grows and u wouldnt let it die
