October 04, 2023, 10:12:54 pm
Welcome, Guest. Please login or register

Arturia Forums

Author Topic: Microbrute Tuning Question  (Read 2165 times)


  • Newbie
  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Microbrute Tuning Question
« on: October 07, 2018, 04:37:47 pm »
Hi, I bought my Microbrute used maybe a week ago. I tuned the middle octave when I first got it and didn't think much of it but when I went to check the bass notes I realized they were a little off. Upon further investigation, I've realized that the lower notes on my Microbrute are sharp and the higher notes are flat and the farther you go in either direction, the worse the tuning gets. Does anyone know how to remedy this?

I did some research and I know that I will probably have to use these two screws on the back of the synth but I'm not sure which one is which-
can anyone help me out?


Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines