May 29, 2024, 04:05:29 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Minibrute Oscillator Mixer problem  (Read 1409 times)

SJ

  • Guest
Minibrute Oscillator Mixer problem
« on: January 13, 2023, 02:12:24 pm »
When everything is set to a neutral point and all Oscillator Mixer faders are down I still get a sound. Only the Sub Osc and Noise faders seem to do their correct function. The Saw and Triangle change the sound slightly, but not by much. The Square wave does nothing to change to sound - the sound I am getting out of it with everything off sounds like the Square wave fader is all the way up! The Ultrasaw and Metalizer still have some affect on the sound, its there but quiet. The Pulse width control does sound how you would expect.

Could the mixer silders be stuck in a position? I have tried moving them with some pressure downwards, but that hasnt shown any results. Has anyone else experienced something like this and can anyone offer any possible solutions?

Thanks


 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines