December 14, 2024, 11:44:44 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Assign Sustain Pedal  (Read 2965 times)

plinyolivier@gmail.com

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Assign Sustain Pedal
« on: May 06, 2020, 11:38:06 pm »
How do you assign a sustain pedal to work with a sample?  I have credits a new user preset using three samples but I cannot get the sustain to work with the sound. 

LBH

  • Hero Member
  • *****
  • Posts: 4.920
  • Karma: 261
Re: Assign Sustain Pedal
« Reply #1 on: May 07, 2020, 01:12:45 am »
Hi and welcome to Arturia forums.

1. In SCR mode select the Assign tab. Please read section "5.4. Assign Tab" in the manual.
2. In the MIDI section you find there - click the MAP button above SUS (sustain) so it turns yellow.
3. In the Envelope section now draw a modulation amount for the Damping you wan't to use (a yelow marking will appear). Be sure to set the DAMP MODE to the damping version you will use.
Now the sustain pedal will work for the slot that was selected.
4. Deselect the MAP button for the SUS again (So the button is'nt yellow anymore), to go out of SUS assign mode, when you are done.

Please read about the difference between two Dampings and about the TRIG in the ENVELOPE section in the manual page 27 (31 of 63 in the PDF page selector).

Hope this helps.

plinyolivier@gmail.com

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Re: Assign Sustain Pedal
« Reply #2 on: May 07, 2020, 03:31:21 pm »
Thank you.  That was very simple.  I wasted hours trying make it work via the midi mapping page.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines