February 21, 2024, 03:23:41 am
Welcome, Guest. Please login or register

Arturia Forums

Author Topic: Keep transpose value through Sequences  (Read 944 times)


  • Apprentice
  • *
  • Posts: 3
  • Karma: 0
Keep transpose value through Sequences
« on: December 15, 2019, 05:20:26 pm »
Something I find very annoying and I did not find any way to avoid it is to prevent the step sequencer to go back to transpose center pitch when you move the Seq selector knob. I would like to be able to have several sequences and to move from one to another without loosing the current transpose offset. To sum up : a new sequence should inherit the transpose value of the previous sequence.

Eg in the control center, the transpose latch setting could have 3 values : off, on, inherit

This is very doable in a new firmware


Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines