Hello. I picked up a Keystep a few months ago and have spent countless hours of unimaginable fun using it to control a Moog Werkstatt without a DAW. So much fun. BUT, now that I want to get serious and compose some music with Cubase 5, there is a problem. When Keystep is connected to PC via USB with Cubase running, the SEQ and ARP act erratically. I'll explain in detail below. It seems to have no effect whether the Keystep is a slave or a master, or what the 'Sync Clock in/out' settings are set to. I've have been unable to find this problem in Arturia forums or Cubase forums.
Perhaps a description of what happens playing a single note in ARP may provide a clue.
I hold down a 'C' and it repeats a single note exactly as one would expect. Pressing a 'C' one octave up or down, however, gets the same pitch, not an octave.
It gets weirder.
'C#' results in the ARP ascending in half steps
'D' results in the ARP ascending in whole steps
'D#' results in the ARP ascending in minor thirds etc...
Similarly, 'B' results in descending halfsteps
'A#' results in descending whole steps
'A' results in descending minor thirds
Returning to any 'C' will play whichever note the ARP decided to land on last.
As soon as I shut off Cubase, it works fine.
I have no other DAW to test this with, and no other Arturia products.
I sense there is something really obvious right in front of me that I am missing.
Thanks for any help.
