Another PRST LINK issue?

[Gabpipes]

Hello!! My BSP is updated with the latest firmware, 1.4.0.20 and many problems are solved, but when I use the PRST LINK button something strange still happens: I play SEQ1 and SEQ2, three patterns in each sequencer; I can move in parallel from pattern 1 to 2 and then to 3 and again to 1,etc. without problems,... but if I stop the BSP on the pattern 1 and change to pattern 2 (always in parallel and with PRST LINK in ON), when I restart the BSP only the pattern in SEQ 2 is changed (the display numbers are correct but not the music). The same thing happens when I pass from pattern 3 to 4 (empty), the music goes out of a pattern that it should be empty. Has somebody else found the same problem? What can I do to solve this problem? Thank you!! Ciao!!
Gab

[atte]

I just upgraded to 1.4, and have initially the same thing happened to me. Went to the MMC and set "pattern link" to absolute and "wait for pattern load" + "wait for project load" to on. Now the BSP is behaving as expected again.

I try to spend as little time as possible in MMC, so the spelling of the functions is by memory, hope it helps!

[Gabpipes]

Thank you! The solution is in the MMC, I was with "pattern link" in absolute, now I have changed to relative and all works well. Ciao!! Gab

[atte]

Ah, yeah, I think that's what I did as well. Good thing it's working for both of us now