Can't use BSP's step sequencer in DAW (Cubase 8)?

[tlec]

Just got my BSP so still getting the initial set up going.

Got it connected via USB into Cubase 8, Which it is detecting correctly on the midi channel, and when the BSP is in USB mode it's tempo slaves to the DAW as it should. but the step sequencer will not play when in USB mode?

I can only get the step sequencer to play when in INT (internal) mode?

Please help, I've already sifted through the manual for answers to no success.

[paulogic]

Did you put the BSP in play mode ? (Just Press Play button and start Cubase).
Works fine here. Just got the BSP yesterday and it is performing as expected.

This may help : https://www.youtube.com/watch?v=OHODr7AKdic

Success,

Paulogic

[tlec]

Its not that simple. Apparently there are quite a bit of steps you have to set up first in Cubase, I found out after Arturia finally sent me this manual. I've yet to try it, but I am sure this is where my issues lies.

These manuals should be made available on their website.

https://drive.google.com/open?id=0B-1e9zXr5JIlamltb2g4dnBDUzA

[paulogic]

Sorry if I made it look simple...

Nice manual. I knew this because I also sync to other devices (SUB37, DarkTime)...

good luck !