Extended sequence >32 will start everytime at 48

[maddyman]

Do has anybody an idea why - if I extend a seq. >32 the start of a pattern using the DAW (logic pro9) will take place at the first step of the third part of the sequence (48).
In INT mode - using BSP for its own - it works fine, but with the DAW I'm in trouble.
Can you check this ?
Thx

[maddyman]

I have the same problem with the Spark, and the Beat Step (not pro) had this in the first firmware release.

It happens when I run my DAW NOT from the very start.
Logic sends the Start message on the downbeat of bar 1. If I start playback somewhere else, it sends a Continue message.

Arturia has solved this problem with the BEAT STEP when the last firmware was released.
Terrym : could you keep this in mind for the future update with the BSP?
Thx

[maddyman]

I solved it.
It depends where the cycle starts.
moving the cycle 4 bars ahaed let the sequence starts at another extendet part of the bsp (the same for the spark)
Only to let you know - if you have the same issue sometimes - even using another daw (like my logic 9 pro)
regards to everybody