Can you make the pads fixed velocity?

[Danyx]

Hi Terry and thanks for answering!
Please could you tell me what you mean by "pas"?
What I do is playing parts on the pads of the BSP in controller or sequencer mode, and recording it in my DAW. Am I supposed to be able to have fixed velocities??? If so, I just cannot do it.

[Terrym]

Hi ,sorry a spelling mistake..... the velocity setting in the mcc is for control mode only  they should output what you set  .are you using midi or usb . I'm on  a different Fw to you but may check later



regards

Terrym

[Danyx]

What a pity you cannot use it in sequencer mode. It would be useful for drums programming to be able to set a min. velocity.
Anyway, I'm using the usb cable and my output setup for each pad in the MCC is "usb & MIDI".

[syrupcore]

Old thread but just in case people search and come across this... with the 1.3 firmware you can adjust all sequenced velocities at once. So, if you want everything at a fixed velocity, you can:

1. Set the knobs to "Velocity" Mode
2. Hold Shift
3. Turn knob #2. 

That will set the velocity all steps. Knob 1 is similar but it adjusts them relative to each other.

[Guy Brush]

Still no fixed velocity for the pads?

[Naterade77]

 Very old thread now.  I just got BSP and I want max velocity when using the melodic sequencer when hooked to synths. 

[fanwander]

Very old thread now.  I just got BSP and I want max velocity when using the melodic sequencer when hooked to synths.

Check the comment of @syropcore from Dec 31, 2015, 12:15:13. It describes how to edit the velocity of all steps of a sequence.

1. Set the knobs to "Velocity" Mode
2. Hold Shift
3. Turn knob #2.

That will set the velocity all steps. Knob 1 is similar but it adjusts them relative to each other.