Minibrute only shows red light over Rate knob when turned on

[realtrance]

Hi,

My MB was working fine for years, then I went to replace the sticky side panel (got a new one from Arturia awhile ago), and when I turned it back on, I only get a red, continuous light on the Rate knob, nothing else.

Have checked the KBD-Gate switch, not a factor.

Won't be recognized via USB.

Any suggestions? I have contacted Arturia via email re: this, I'm hoping someone has an idea. Have opened and attempted to reposition the cables, they seem tight so that's not it (also not crushed by reassembly).

Thanks,

RT

[realtrance]

Okay, update on this: apparently I apparently lifted a transistor off the mainboard with one of the blue-white wires inside when removing the I/O daughterboard to make sure the cable was on right upon reassembly.

So..... one dead MiniBrute to report.

Can't afford it, but purchased an MB2 to replace it, which I hope has the same characteristic sound and oscillator mixing options!

Nothing for Arturia to do except weep with me for the demise of my Minibrute.