3D waveform display bug (morph off)

[Biome Digital]

I have noticed a little inconsistency with the 3D waveform display when the "Morph" is off.

Easy to replicate.

Load basic waveforms. Switch off "morph". Move wavetable position between the 4 waveshapes and you will notice that sometimes the waveshape shown is not the waveshape heard.

Of course this isn't a big problem; it's just something I noticed.

[Jpro600k]

If Morph is off, the waveform will be only switched.This is because no waveform is generated between them.

[RomusD]

Load basic waveforms. Switch off "morph". Move wavetable position between the 4 waveshapes and you will notice that sometimes the waveshape shown is not the waveshape heard.

I can confirm that

[Jpro600k]

The change value of the knob from the square to the saw is too small, so there is a possibility of a bug.
value is 1 to 0.999.

[Jpro600k]

Check attached file.
The value of the knob and the switching range of the waveform are not matched.

[Terrym]

Hi All, This is not a big deal but i will point it out to the test team. if you change to 2D it is working fine there. so its just a graphic alignment for 3d


Thanks

[Biome Digital]

If Morph is off, the waveform will be only switched.This is because no waveform is generated between them.

I know that.

[Biome Digital]

Hi All, This is not a big deal but i will point it out to the test team. if you change to 2D it is working fine there. so its just a graphic alignment for 3d


Thanks

As I said in my post, it's not a problem, just something I noticed. It is nice when the display follows the sound though.