I bought a stereo splitter cable for sending clock and reset from the BSP to my eurorack modular. I've been annoyed by the running gate output, since inputting this into a reset makes the module reset forever, meaning it's not running at all. For a while I used a high pass filter module to filter out the DC, effectively making the running gate a reset trigger. However this means the filter is stuck with this duty, where I'd obviously rather use it as a filter.
So I googled a bit, and today I did a dead simple (1 resistor, 1 cap and 1 diode, < .5 euro total) passive hpf, build into a small male-female mini-jack cable. Works like a charm
![Smiley :)](http://forum.arturia.com/Smileys/classic/smiley.gif)
Sharing it in the hope it might be useful to others.
Here's a three part video (instagram), part 1: no reset, part 2: running gate makes sequencer stop forever, part 3: with the filter it works as expected.
https://www.instagram.com/p/BDaoZqomHZf/![](https://dl.dropboxusercontent.com/u/4343030/passive_hpf_1.jpg)
![](https://dl.dropboxusercontent.com/u/4343030/passive_hpf_2.jpg)
![](https://dl.dropboxusercontent.com/u/4343030/passive_hpf_3.jpg)
![](https://dl.dropboxusercontent.com/u/4343030/passive_hpf_4.jpg)
![](https://dl.dropboxusercontent.com/u/4343030/passive_hpf_5.jpg)