Pad Velocity Sensitivity Ridiculously Low

[davidmolina]

I just purchased a Keylab 49 Black and I'm trying to set up the pads but their sensitivity is exremely low. In order to get some decent velocity out of them I have to hit them ridiculously hard and I feel I will break them, besides my fingers just hurting after 4 or 5 hits.

I've tried every Pad Velocity Curve in MIDI Control Center but they are all way too low or just a single very high velocity. I've read about several people having the same issue. Anyone know of a fix or setting? I have the latest firmware installed.

[Jorgalad]

I think it might be the latest firmware, for some reason my pads only send a max value of 110 velocity since the upgrade

[davidmolina]

Yes, that was it. Thanks! I just reverted back to v1.29 and it mostly corrected the issue. I still can't go past around velocity 120 but at least I've got much better response now. Hopefully they correct it soon!

[Jorgalad]

Thanks for verifying, now I'm considering going back too. Although I changed most of my code already to work with this new system. I also noticed that using the keyboard to edit values (like velocity curves) often does a better job than the software editor.
So you could try that for the pads.