November 01, 2024, 12:49:42 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Does the BSP accept MMC (MidiMachineControl) commands?  (Read 2370 times)

maddyman

  • Jr. Member
  • **
  • Posts: 65
  • Karma: 13
Hi
I would like to remote control the start and stop of the BSP via MMC (Midi Machine Control) commands.
Bescause there are no other ways to let the BSP starts and stop at different and multiple points of my Logic arrangement.
Is there any way to do this by the MMC commands?
Somebody in the Logic Forum supposed this could be working fine (if the BSP recognizes these commands)
thank you for any advise
regards

maddyman

  • Jr. Member
  • **
  • Posts: 65
  • Karma: 13
Re: Does the BSP accept MMC (MidiMachineControl) commands?
« Reply #1 on: June 09, 2017, 04:33:20 pm »
Therefore I waitet for so long and nobody knew an answer I phoned today to TOMESO, the german part of Arturia.
They answered: yes the BSP understands MMC commands.
This information for those who are interested in.

megamarkd

  • Hero Member
  • *****
  • Posts: 835
  • Karma: 38
  • Dead By Dawn
Re: Does the BSP accept MMC (MidiMachineControl) commands?
« Reply #2 on: June 28, 2017, 02:10:09 am »
This information is also in the manual.
Currently running https://www.modulargrid.net/e/racks/view/1311723 / www.modulargrid.net, sequencing with KSP and recording with a Zoom (no DAW involved, for better or worse ;) )

I grec

  • Firmware Wizard
  • Administrator
  • Sr. Member
  • *****
  • Posts: 436
  • Karma: 24
Re: Does the BSP accept MMC (MidiMachineControl) commands?
« Reply #3 on: July 03, 2017, 04:50:16 pm »
Hi guys,
Sorry but no, BSP does not understand incoming MMC commands. It can only send MMC to other devices.
It may be done some day but it may (will! -> Murfy's law) create MIDI loopbacks if the users are not aware of how to use it. That's why it is not possible right now...

Regards,
Y.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines