CV issue with Roland SH-2

[keredsenoj]

Hi - finally got my hands on a BeatStep - love it.

An issue i'm having is my SH-2 synth is only getting Gate from the Step Sequencer - No pitch. All the wires are plugged in the right places. The Sh-2 works fine with CV/Gate from my MiniBrute, so the cables etc are fine.

Anyone else having similar issues with Vintage synths?

D

[CFM]

There seems to be loads of problems with the beatsteps CV - not working with the Stylophone S2

[ganglio]

Same issue with sh-101. No pitch

[Terrym]

HI, i found that beatstep doesn't work with all synths with cv gate . when i was testing this  arturia are aware of this and in the manual it states to check  that beatstep will work with your instrument . beastep is a 1volt per octave (7 volts)and upto 8 volts on gate. but i have found the gate could be as low as 5 volts. beatstep doesn't work with my roland stuff that has kenton cv fits from the 90's. (gate 10 volts)

so check your instruments

regards

terrym

[r23d]

Hi Keredsenoj and Ganglio,  the SH-2 and SH-101's CV specs match up with the beatstep so it should work.

I think the comment in the manual about the beatstep not working with some synths refers to the Hz/volt and s-trigger kind of standards Yamaha, Korg and others used.   

The beatstep outputs in 1v/octave and gates at +8v according to the manual
For the sh-2, CV is in       1v/octave and gate is anything above about 7.5v
For the sh-2, CV is in       1v/octave and gate is anything above about 2.5v

Mbe check your cable, sockets etc?

Anyone else have a working cv/gate link with these synths?

Good luck!

Rich

Richard

[r23d]

Just another thought keredsenoj, I'm assuming you've tried using your beatstep to drive the minibrute via CV to test the CV out of the beatstep to check it's working OK.  Worth testing if u haven't tried...

[r23d]

Terrym, have you tried using a voltage step-up converter to get the gate working on your old rolands?

For about $2 it might be worth getting one and making up a little inline circuit to get the gate signals up to 10v if it can operate fast enough :

http://www.ebay.com.au/itm/DC-DC-Adjustable-Step-Up-Power-Converter-XL6009-Module-Board-4A-Maximum-Current-/251454403276?pt=AU_B_I_Electrical_Test_Equipment&hash=item3a8bd9b2cc&_uhb=1

ok, I'll shut up now...

rich

[Terrym]

Hi thanks for the advise but i spoke to kenton and was advised i could take out a resistor from my tb303 kit and this would step down the voltage needed to power it .but I'm not going to do that as i  have a dedicated cv box from kenton .and i can plug the beat step into it via the midi port.

regards


terrym