Lab (and SEM) Loops & Sequences in Ableton Live

[Lotusx42]

Starting to get to grips will pulling things together, however when I record automated drum loops and sequences from Scene mode (and also arp's from SEM) into Live, while they record fine, they don't stop when the playback is stopped - almost like there is no "note off" command being sent.

The only way to stop playback is to delete the scenes from Live and start again.

Any ideas?

Greg

[Manuel]

Hallo Greg,

I think you should try to change the settings for the pads from "loop" (Pad 1-3) to "gate" (like Pad 4) or better to "trigger". Or you have to set a "stop-note" so that the "loop" knows when it should stop.

I can't say much about the SEM right know but this should work for the pads.

Here you'll find some Solutions! working in most DAWs.

Don't forget to applaud for me if these tips were helpful for you!  

Best regards

Manuel

[Manuel]

Hi Greg,

The Oberheim SEM V beta should fix this issue. If not, have a look at this thread or contact Tech Support.