So where in all the FAQ's or manuals is multi-mode actually explained?

[pax-eterna]

Thread title says it all   can anyone point me to resources that fully explain this mode, rather than just state it has multi mode?

Thanks

[zenbob]

Its in the Analog Lab manual. In the latest Analog Lab 2.0 manual its section 3.5.

[pax-eterna]

ahhh thanks. So multi mode is not all that flash then. Still only two parts. When will Arturia get with the 21st century and allow rx/tx on all 16 channels?

[Tausendberg]

I would love to be proven wrong but to answer your question, I imagine 16 channels will come only with the successor to the keylab line.

[pax-eterna]

yeah you are probably right, but if Arturia can "magically" get the power supply to recognise a 9volt power pack simply by updating firmware, maybe they can do this as well 

[Tausendberg]

I figure that all depends on the limitations of the hardware. I imagine adding more channels costs more processor power and, you know, because this is only a controller, the processor on the Keylab line might be somewhat minimal.