Possible to calibrate the filter?

[dermich]

I'm really loving my MicroBrute, but my filter doesn't seem to be calibrated exactly. When I switch to high-pass mode and turn the cutoff all the way up, I still get a bit of audio signal. It takes me to total silence when in low-pass mode with the cutoff all the way down.

Can I fix this myself?

[Yanneck]

Look at this thread: http://www.arturia.com/evolution/smf/index.php?topic=14538.0 -> Side 2

I got my second Microbrute today. Will went to store again tomorrow. Early bird catches the worm, early adopter catches bugs. 

[Bruno@arturia]

Look at this thread: http://www.arturia.com/evolution/smf/index.php?topic=14538.0 -> Side 2

I got my second Microbrute today. Will went to store again tomorrow. Early bird catches the worm, early adopter catches bugs. 

I don't think this answer is related.

By design the HP filter does not completely close, only the LP does. So you can't calibrate it.

[Yanneck]

Is it possible that this depends on calibrating the modwheel? Since I've done that I was not able to trigger Microbrute to play forever.  Before calibrating  it was easy. I will test it a little bit. Hm.

[Bruno@arturia]

Since I've done that I was not able to trigger Microbrute to play forever.

For the sequencer it's an option is Microbrute Connection: "hold"
for Gate hold you can check this:
http://www.arturia.com/evolution/smf/index.php?topic=14378

[Yanneck]

I think, you get me wrong. I will try to make a video of it. If I do Highpass, Cutoff 50%, Resonance Max and then playing with amount and rate of lfo it sometimes hangs up and plays forever without sequenzer. Since I've calibrated the Modwheel I was not able to trigger this. I will try to kick it when I'm at home.

[dermich]

Thank you Bruno - that is exactly the answer I needed. This is definitely my favorite synth I've bought in ages.