Rotary controllers not mapped correctly

[simonc123]

Hi, I'm new here, so apologies if this has been covered before.

I've just bought a Keylab 49 BE and it works fine with the VCollection synths running stand alone.

However, if I run the synths via Analog Lab the Keylab rotary controllers are off set as follows:

Keylab Controller 1 - mapped to Analog Lab Controller 2
KL C2 - mapped to AL C3
KL C3 - mapped to AL C4
KL C4 - mapped to AL C4 (note doubling up)
KL C5 - mapped to AL C5

I'm using the factory default mappings running on an iMac.

Any ideas please?

Cheers.

[ben arturia]

Hi simonc123,

I'm not sure to understand your pb here.
Do you mean that knob 2 is mapped on GUI knob 3 ?

Could you try to reboot your kl while pressing oct + and - in order to reset the kl the factory settings ?

[simonc123]

I re-assigned the controllers manually and that worked