Low profile knobs ?

[Sweyn]

Hello there.

I got a keylab a few months ago and set in on a keyboard tray beneath my desk. Only problem, to sit flush I had to remove all of my CC knobs. (Top right knobs, there's only knobs there but who knows)

I was wondering if anyone found arturia compatible low profile knobs I could buy or 3D print. Maybe I can sand the top of my already existing knobs ? Here's a picture of my issue : https://imgur.com/a/R8gHpNt

I could also lower the tray, but then I would lose leg space, which is already pretty tight. I can still use the CC controls without the knobs but it's pretty ghetto and looks bad.

[diex68]

I just did a search for control knobs, there are a log of knobs out there  .  I would just do some proper measurements and you should find something.