Arturia Forums

Hardware Sequencers => KeyStep => Keystep Technical questions => Topic started by: bogcore on February 10, 2019, 07:06:29 pm

Title: Midi control center won’t recognise keystep
Post by: bogcore on February 10, 2019, 07:06:29 pm

Keystep just won’t show up in the midi control center. Keystep is in midi mode, my pc is recognising it, it works (mostly) fine as a controller with fl studio. What am I doing wrong?

Title: Re: Midi control center won’t recognise keystep
Post by: MajorFubar on February 11, 2019, 04:31:54 pm

Welcome.

Leave the keystep in its default mode. MCC should then recognize it. If you are able, try a new USB lead. If neither of those things work, try a factory reset by holding down the octave up/down buttons while powering it up (three hands are useful here because the Keystep lacks a power switch). If all those things fail, raise a support ticket with Arturia.

Hope that helps.

Title: Re: Midi control center won’t recognise keystep
Post by: bitbin on March 13, 2019, 05:17:41 pm

Same issue here.