Arturia Forums

Software Instruments => SEM V2 => SEM V2 - Technical Issues => Topic started by: LBH on November 02, 2018, 08:30:52 pm

Title: Is this noise and click supposed to be?
Post by: LBH on November 02, 2018, 08:30:52 pm

I have allways wondered why SEM V give lots of noise when you zero every parameter, and there should be no sound at all. It's like the noise is'nt turned off completely.

Also there is a huge click on note on, especially when in MONO mode. It's very loud on sounds where the filter frequency is at a low setting.
The same click does give a kick to some sounds.

Is this how it's supposed to be?

Title: Re: Is this noise and click supposed to be?
Post by: DW on September 16, 2020, 05:55:37 am

I hear it too. I doubt they spend resources to fix it at this point. Moved on to the Xa.