Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: lorenzosetti on June 21, 2018, 12:06:29 am

Title: [SOLVED] - Issue switching between programs
Post by: lorenzosetti on June 21, 2018, 12:06:29 am

Hi everyone!
I noticed that after the latest update (2.0.1.6) my bsp, after switched between program X to program X+1 doesn't reset the pattern to one, instead when I uploaded the new program it belongs to the pattern in which I was before (at the previous program).

e.g.
Switching between prg 1 pattern 8 to prg 2, while playing, the prg 2 will start from pattern 8 instead of pattern 1 (that's how it did before the firmware update, and how i need!)

Hope someone could help as fast as possible 'cause i've many gigs to do..
Thanks for your time

L

Title: Re: Issue switching between programs
Post by: I grec on July 06, 2018, 03:16:50 pm

Hi lorenzosetti,
I guess "program" means "Project".
Yes this is a normal behaviour.
If you put Scene mode to "On" in the MCC, it should behave like before, if your scenes are empty.
You can also change the pattern to 1, then change the project, but only if you are in "Wait to Load Pattern" mode.

Regards,
Y.

Title: Re: Issue switching between programs
Post by: lorenzosetti on July 09, 2018, 10:40:46 am

Hi,
thanks for your time! Now it works like before.

L