Arturia Forums
Hardware Sequencers => KeyStep => Keystep Technical questions => Topic started by: wajobu on May 28, 2018, 02:02:51 pm
-
Hi,
I have two KeySteps. One pitch slider gives me one octave up and one down when I use it, the other only gives me what sounds like 1/2 octave up and down. Is there a way to make the 1/2 octave slider match the other KeyStep full one octave up and down? This is new, out of the box operation, I haven’t done any factory resets or anything to either KeyStep.
Thanks in advance.
-
Hmm, no one?
Bueller? Bueller?
-
Voodoo-economics.
Umm, yeah. 1986 was 32yrs ago. Last time I made that reply reference, the OP didn't even know the reference despite making the original roll-call reference.
Is this over MIDI or CV? Have you checked them using Midi Control Center? You can't specify the bend range via MIDI but you can for CV pitchbend.
-
Both are over MIDI.