Arturia Forums

Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: tonaldefiance on April 30, 2018, 10:28:00 pm

Title: Send midi out on seq 1
Post by: tonaldefiance on April 30, 2018, 10:28:00 pm

The answer is probably staring me in the face.

I am powering the BSP with a USB hub. seq 2 is sending cv data to my Moog dfam. I have the Midi out cable plugged in to the out and its going to my midi modified korg monotribe but i dont know how to tell seq 1 to send midi data out instead of cv.

Pouring through the manual i am not seeing how to do this. i have the Midi control center so i was hoping someone could walk me through sending midi data through the midi out.
can all the sequencers including drums be told to go through midi?

Thank you

Title: Re: Send midi out on seq 1
Post by: megamarkd on May 01, 2018, 02:51:09 am

MIDI data is sent along side CV, what it sounds like is going on is you have different MIDI channels assigned to the sequence and the Monotribe.  I don't know how to set the channel on the Monotribe, but an easy way to find which channel it's on id to cycle through the channels seq2 is sending on.  You'll hit the right one in no more than 30sec.  Have fun!

Title: Re: Send midi out on seq 1
Post by: I grec on May 02, 2018, 08:43:38 pm

Hi tonaldefiance,
megamarkd is right. BSP always sends data to both MIDI and CV. It must be a MIDI channel issue. Sequencer 2 is set to channel 2 by default.

Regards,
Y.