Arturia Forums
Hardware Instruments => MiniBrute 2S => MiniBrute 2S - General Discussions => Topic started by: Predator on April 25, 2018, 07:53:29 pm
-
Is there a way to route ModWheel to the Filter Cutoff? Or am I missing something?
The Key version is routed by default to the Cutoff, but the S version seems to lack this...?
Busting my brain over this.. can't figure out how to route the mod to the cutoff, please advice.
Thanks!
Stephan
-
The Minibrute 2s has no mod wheel but by default has aftertouch set to filter cutoff; can you map the modwheel to aftertouch?
Not sure what the CC will be - perhaps 2 or 4. I'm sure the answer will reside in sending Midi messages to Mod1 and/or Mod2 but I haven't found how to do this.
-
Page 148 of the manual indicates that one can change the Modwheel CC from 1 to anything else. If your DAW is using something other than CC#1 or if your MTC shows the modwheel CC set to something other than CC#1 then perhaps this is the issue. This is presuming that the Minibrute 2s should be interpreting modwheel CCs to one of the mod CV outputs.