Arturia Forums
Harware Legacy versions => KeyLab => Topic started by: johnson66 on September 20, 2017, 02:45:10 pm
-
Hi,
My Volume, Category and Preset buttons on my Keylab49 doesn´t seem to work. When I try to run through the sounds or change the volume in AnalogLab 2 by turning one of buttons it doesnt toggle the sounds or change the volume. It only shows some parametres in the keylabs display:
"CategEnc" and "Ch" and some values.
What could be wrong here?
I have the newest firmware.
-
any solution to this ?