Arturia Forums
Hardware Instruments => MatrixBrute => MatrixBrute - Technical Issues => Topic started by: ijt33 on May 13, 2017, 12:32:56 pm
-
Hi, I am on Firmware 1.1.0.73 and the Sequence Mod appears to have stopped working - if I select a Cell in the Mod row an turn the mod amount dial it only shows zero ? Is this a known problem - help please
-
This is a known bug in 1.1.0.73.
You can consistently fix it by pressing Record and Play simultaneously. It may get stuck at +/-0 again after a while, but you just repeat the Record+Play trick and it works again.
-
OK, I can sometimes (...) set values after pressing Record and Play simultaneously - but using Seq Mod (with some activated MOD steps) appears to have no effect anyway.
EDIT: Now it works, after rebooting the Matrixbrute.