Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - Feature requests => Topic started by: khidr on January 10, 2017, 09:50:57 am

Title: Set sequencer starting point
Post by: khidr on January 10, 2017, 09:50:57 am

Currently the sequencer will always start at position one. It is possible however to change the end point of the sequencer.  It would extend the usefulness of the sequencer enormously it were also possible to change the starting point of the sequencer. If for instance you have a long sequence of 40 steps you could then isolate part of it   (during performance?) in smaller 4 step sequences.
To take that further: if you could make start and end point things that could modulated in column 13-16.......

Title: Re: Set sequencer starting point
Post by: DrJustice on January 10, 2017, 05:15:57 pm

+1

Title: Re: Set sequencer starting point
Post by: lensflare on January 21, 2017, 09:33:58 pm

+100  ;D

Title: Re: Set sequencer starting point
Post by: ben arturia on January 23, 2017, 11:10:37 am

Hi guys,

Your feature had been listed here !
Thanks !

Title: Re: Set sequencer starting point
Post by: SoundRider on March 12, 2017, 02:17:58 pm

Yes ... I am missing this too, please!

Title: Re: Set sequencer starting point
Post by: VAU on March 12, 2017, 05:59:02 pm

also great would be independent lengths of MOD TRACK and NOTE TRACK
(for example that would make it easy to have the same 8step Modulation repeating over 4 bars
(a copy and paste function wouldn't be that bad either...)

and the ability to shift them left and rigth (track rotating) stepwise