Arturia Forums
Hardware Instruments => MiniBrute => Topic started by: pulpum on October 03, 2016, 12:45:16 pm
-
hi all.
I'm very happy with my minibrute BUT I have one problem...
my lfo led does not blink and I hear modulation only with sine / triangle / saw / square waveforms.
When I try lfo with the two last waveforms, I hear (at best) only a lower volume if I turn lfo rate.
I have tried several firmwares but the problem was here before the last firmware...
a bit annoying!
if you have any clues... thank you!