Arturia Forums

Harware Legacy versions => KeyLab => Topic started by: pax-eterna on April 17, 2016, 11:06:44 pm

Title: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: pax-eterna on April 17, 2016, 11:06:44 pm

Thread title says it all :)  can anyone point me to resources that fully explain this mode, rather than just state it has multi mode?

Thanks

Title: Re: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: zenbob on August 12, 2016, 09:27:13 am

Its in the Analog Lab manual. In the latest Analog Lab 2.0 manual its section 3.5.

Title: Re: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: pax-eterna on August 13, 2016, 06:46:48 pm

ahhh thanks. So multi mode is not all that flash then. Still only two parts. When will Arturia get with the 21st century and allow rx/tx on all 16 channels?

Title: Re: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: Tausendberg on August 14, 2016, 01:51:51 am

I would love to be proven wrong but to answer your question, I imagine 16 channels will come only with the successor to the keylab line.

Title: Re: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: pax-eterna on August 14, 2016, 06:04:34 am

yeah you are probably right, but if Arturia can "magically" get the power supply to recognise a 9volt power pack simply by updating firmware, maybe they can do this as well  ???

Title: Re: So where in all the FAQ's or manuals is multi-mode actually explained?
Post by: Tausendberg on August 14, 2016, 10:40:18 am

I figure that all depends on the limitations of the hardware. I imagine adding more channels costs more processor power and, you know, because this is only a controller, the processor on the Keylab line might be somewhat minimal.