Arturia Forums

Hardware Instruments => MiniBrute => Topic started by: arturio on February 13, 2016, 03:25:22 pm

Title: Minibrute stuck in Arpeggiator "HOLD" Mode
Post by: arturio on February 13, 2016, 03:25:22 pm

Hi folks, I'm new here and I've got the Minibrute to evaluate for today and tomorrow. Since time is limited I'm starting this topic right away.

To check out the sounds and mess around with the knobs of the MiniBrute etc. I let the arpeggiator play a sequence in hold mode. Doing so, I've already had 5x that the minibrute gets stuck, hanging itself completely up, playing continuously the last note when he got stuck.

Oscillator, Filter, Envelopes etc. controls still work, the arpeggiator, the octave knob, mod and pitch wheel, are stuck.

The only way to remedy this is to turn the Minibrute off and on again.

Is this a known issue? I like the sounds etc. and intended to buy the MB, but now this lets me hesitate a bit.

Thanks

Title: Re: Minibrute stuck in Arpeggiator "HOLD" Mode
Post by: bennymo on June 22, 2016, 04:35:09 pm

Can you reinstall the firmware update maybe?

Title: Re: Minibrute stuck in Arpeggiator "HOLD" Mode
Post by: MBlanc on July 01, 2016, 06:37:26 pm

Hey ! Thank you for your participation   ;D

I just did it but no change.
Maybe the software Minibrute connection can be important with the sync source ?
In an other way sometimes the arp look like unfonctional...


Are these fact common ? How to solve them ? Yesterday the arp was great !

Title: Re: Minibrute stuck in Arpeggiator "HOLD" Mode
Post by: PolitiKill1992 on November 09, 2016, 08:20:59 am

any news guys?  ??? im trying to solve the same issue.