Arturia Forums
Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: LADO on September 01, 2015, 10:51:15 pm
-
Hello
Is it possible to set note range in bsp?? When i turn knobs it goes too low or too high. Can i set it from midi control center that it goes couple of notes up or down and not all the way High or low.
Thank you
-
Have you tried adjusting knob acceleration (12.8.4.1 in the manual) to a lower value. If you spin them to aggressively they will fly through the values.
-
any other suggestions ?
-
You can also input values from the pads or an external keyboard