Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: Marcel_mendes on July 21, 2015, 12:38:51 am
-
I wish this all was a bad joke, but is not... Turned the microbrute into a correct power source using the 12v original power cable, waited 5 minutes to warm... All happiness, them i've turned up the attack: 3 "tec tec tec" noises and it went dead!!! 5 MINUTES!!! 5 MI-NU-TES!!
I'm from Brazil, where there is no support....! 320 euros to trash, or there is any hope?? Paper weight or there is some kind of light outside the tunel??
-
Hi !
Sorry you are encountering these issues,
First make sure nothing in your patch is preventing the sound from coming through :)
Try a preset shown here to make sure of that : http://forum.arturia.com/index.php?board=124.0
Second, this kind of scenario is often caused by a faulty PSU adapter. Usually changing to a new one does the trick.
Check your PM ! :)